How to repair the dripping water of the laboratory faucet?

The key is that the pivot seal inside is broken, just replace it with a new one. Usually, it can be replaced by itself, which is relatively simple.

Apart from the broken pivot seal, what are the reasons for the faucet to seep water? How can you solve it?

In fact, most faucets have water seepage, which is more or less related to the valve core. We can see from the following situation:

The valve center of the laboratory faucet is not tightly closed

Sometimes the water in our home is very poor, which will cause a lot of waste to be accumulated in the faucet. If we do not remove it on time, it will cause the valve core inside to not close tightly, and the faucet will seep water. At this time, we can remove the faucet and clean it to see if the water seepage has improved significantly.

The faucet valve core is loose or offset

The loosening offset will be divided into two situations. One is that the pressure cap is loose and the water cannot be sealed, so we only have to tighten the pressure cap; the other situation is that the rubber ring at the bottom of the valve core is deformed and cannot be stopped. At this time, you only need to calibrate the rubber ring.

Damaged faucet valve

When the valve core is damaged, all you have to do is remove the old valve core and replace it with a new one.

Laboratory faucet price

The faucet used in the chemical laboratory should have strong corrosion resistance and better material, and it is a little more expensive than the ordinary faucet, usually only a few hundred yuan. And it depends on your total, if you buy more, the price will continue to be cost-effective.